Hallo
Een vraagje
Ik fiets met shimano koersschoenen met de gekende gele
Spd sl plaatjes (gele)
Grijze vierkante stukjes en umbraco van erbij zit gemonteerd in zool van schoen.
Na enige fietstochten kan ik altijd umbraco wat bijdraaien?
Schoenen zijn nieuw stuk of 6x gedragen nog maar.
Is dit normaal dat je ze kan nog stukje bijdraaien?
Voor rit draai ik ze vast,na rit kan ik beetje aandraaien….
Is dit iets die hem moet zetten ofzo……
Op koppel aanspannen is niet aan orde zeker?
Shimano spd sl plaatjes
Ik merk ook wel dat er af en toe een boutje lichtjes los komt, maar na elke rit zou echt niet mogen.
Shimano zelf, raad aan de boutjes vast te zetten op ongeveer 5 a 6 Nm.
Misschien zet je ze niet vast genoeg?
Start by placing a small dab of grease into each of the captive nuts on the base of your shoe and then use a torque wrench with 4 mm hex bit to tighten the bolts to Shimano’s recommended torque setting of 5-6Nm (43-52 IN LB). The grease helps keep the bolts from seizing in place, while following the recommended torque setting assures the bolts are sufficiently secure but not overtightened, which can damage your shoes or the bolt.
Misschien zet je ze niet vast genoeg?
Start by placing a small dab of grease into each of the captive nuts on the base of your shoe and then use a torque wrench with 4 mm hex bit to tighten the bolts to Shimano’s recommended torque setting of 5-6Nm (43-52 IN LB). The grease helps keep the bolts from seizing in place, while following the recommended torque setting assures the bolts are sufficiently secure but not overtightened, which can damage your shoes or the bolt.