Fiets - Race en MTB website voor wielrenners, sportieve fietsers, mountainbikers
https://www.fiets.nl/forum/
The bearings are a mild press fit into the frame. In aluminum frames only, it is recommend to either grease the pressed surfaces or to use a mild thread locker. This may seem contradictory, but the idea is to prevent future creaking if the cup were to move. The cartridge bearing is intended to be a permanent part of the adapter and the unit is replaced together.
Vlgns Wheelsmanufacturing in carbonframe licht invetten, https://wheelsmfg.com/tech/PDF/BB86-92- ... NS-WEB.pdfabsolutluc schreef: ↑25 mei 2019 09:14 Hej,
Zal een bottombracket BB86 campagnolo monteren in een carbonframe en weet niet of ik ze moet insmeren of droog monteren ?
bedankt,
Luc